2-Inch PVC Shower Base Drain with Matte Black Cover
The Allora USA AL5-08-BL is a 2" PVC shower base drain with a 4-1/4" screw-in cover in matte black. The black PVC body and receptor base solvent-cement to 2" Schedule 40 PVC DWV pipe. The matte black cover matches black faucets, valve trim, and door hardware. Spec it when the project calls for a black fixture package. The drain fits preformed shower bases in fiberglass, acrylic, and molded stone. The threaded drain body and the receptor base clamp the base from both sides. An NBR rubber washer and a fiber washer seal against the underside. Once the cemented joint cures, it will not loosen, back off, or weep. There are no mechanical connections to re-tighten after installation. Two black-matched stainless steel screws hold the cover in place. Crews can pull the cover with a screwdriver for drain access, cleanouts, or punch-list work. The matte black coating over stainless steel hides water spots and fingerprints better than bright finishes. The PVC body is unaffected by hard water and common cleaners. Solvent cement connection to 2" Schedule 40 PVC DWV pipe Receptor base and threaded body clamp the shower base from both sides NBR rubber washer and fiber washer seal the underside of the base 4-1/4" round cover in matte black with two matching screws Cover removes with a screwdriver for drain access and cleanouts Fits preformed fiberglass, acrylic, and composite shower bases Black PVC body will not rust or corrode Matte black finish matches black faucets, trim, and hardware Hides water spots and fingerprints in daily service