CLE Type Current Transformer | ABB

Call for Price: (800)-766-1212 Variant Cut Sheets CLE 2000:5 7524A63G01 | CLE 3000:5 7524A63G02 | CLE 4000:5 7524A63G03 | CLE 5000:5 7524A63G04 | CLE 6000:5 7524A63G05 | CLE 1000/2000 7524A63G06 | CLE 1500/3000 7524A63G07 | CLE 2000/4000 7524A63G08 | CLE 2500/5000 7524A63G09 | CLE 3000/6000 7524A63G10 Product features • 600 volt, indoor or outdoor • 10 kV BIL, 25 - 400 Hertz • 8.25" (210 mm) window opening • Window plates and bar-types available Application The CLE is primarily used for high current metering on low voltage systems and is available in single or dual ratios. It can be used with uninsulated bus bar or cable up to 600 volts, or with insulated primary conductors at higher voltages. Construction and insulation The ring-type core and fully distributed winding are assembled to a glass filled polypropylene window liner and injection molded in thermoplastic rubber. The thermoplastic rubber insulating material is permanently molded to the core and coil assembly, resulting in a compact unit with excellent mechanical, thermal, and dielectric characteristics. Secondary terminals and cover The CLE is supplied with large compression-type terminals with slotted head screws, a short circuit device, and a clear, rectangular snap-on cover suitable for locking with a meter seal. This clear plastic cover allows a visual check of connections and is keyed to ensure the shorting clip is across the terminals when no wires are connected. This safety feature avoids dangerous voltages across the secondary terminals if the primary is energized. The center post also serves as a third terminal on dual ratio transformers. Primary The large 8.25" (210 mm) window allows for multiple primary conductors. Optional Micarta® window plates are available to change the window opening to a cruciform configuration for direct bus bar sleeve mounting. Mounting Optional two-piece mounting feet are constructed of corrosion-resistant aluminum. The CLE may also be secured to a wall panel or bracket by using mounting holes in the transformer body. Test reports Test reports are stored electronically and can be e-mailed in various formats at the time of shipment. Standards This unit meets or exceeds all requirements of IEEE C57.13-2016 and can be tested to other standards as requested. UL Recognized Component The CLE is a UL Recognized Component (file number E96461).